Wondering how to change the battery in Honda key fob?

---

The team at Gates Honda can walk you through how to change Honda key battery components. We’ll teach you how to open Honda key fob components to complete a proper battery replacement. Read on to learn how to conduct a Honda key fob battery replacement in your Lexington garage. With this comprehensive guide, you’ll know how to change a Honda key battery no matter what situation you are in. Learn more about how to open a Honda key fob today!

Honda Key Battery Type

Finding a Honda key fob battery replacement is simple! The Honda key battery can be found in many stores around Winchester. The Honda key fob uses a flat circular 3-volt battery. If you are questioning whether or not you have the corrent Honda key fob battery type, you can always contact our parts department.

How to Open Honda Key Fob

Learning how to open your Honda key fob is quite simple! To open a Honda key fob, simply:

1. Locate the button to release the metal key inside the fob. Slide that button open and pull the key out.
2. Carefully place the edge of the key into the slot at the top of the key fob. Wedge the key and lightly twist, the back of the key fob should pop off.

How to Change Battery in Honda Key Fob

Once your fob is open, be sure it does not fall apart. Follow these expert tips to keep your fob intact while replacing your Honda key battery:

1. Hold your thumb right above where the battery is located.
2. Using your other hand, carefully pry the dead battery out and replace it with a fresh one.
3. Line the back of the key fob up with the front half, gently press the pieces back together. Once secured, you will hear a snap.

How to Program Honda Key Fob

Now that you know how to open a Honda key fob and swap the battery, learn how to program a Honda key. Program a Honda key with these simple steps:

1. Enter the cabin, securely shut all doors, and have your key and fobs to be programmed ready.
2. Insert the key and turn to the “On” position. Press and hold the “LOCK” button for one second.
3. Release the button and turn the key to the “Off” position. Repeat this process twice more.
4. Turn the key to the “On” position and hold the “LOCK” button on the key fob for one second. Wait for the doors to lock and unlock automatically. Once the locks have cycled, your vehicle is in remote programming mode.
5. Once again hold the “LOCK” button for one second. Once the locks cycle, the key fob has been successfully paired with your vehicle. Repeat the process with any additional fobs that need programming.
6. Exit remote programming mode by turning the key to the “Off” position in the ignition.

Expert Service Tips and More at Gates Honda

Whether you’re looking for new Honda vehicles or service tips and tricks, Gates Honda is here to help. Contact us today for exceptional service and insightful Honda car care! Visit us near Berea for all of your automotive needs!